This featured XeteX project is a custom energy recovery ventilator with an enthalpy flat plate heat exchanger for an airport application.
Enthalpy plate heat exchangers are designed to efficiently transfer heat and moisture between two separate air streams, resulting in significant energy savings.
Specifications
- Model: XHS-30-60-BP-CW-HW-FF
- Height: 72”
- Width: 75”
- Length: 206”
- Weight: 5,700 lbs
- Supply CFM: 4,300
- Capacity
- Cooling: 222 MBH
- Heating: 230 MBH
- Enthalpy Plate Total Effectiveness
Construction
- Four-section split indoor unit
- Double wall thermal break construction with 2” injected foam
- 18 ga galvanized exterior
- 22 ga galvanized interior
Other Features
- XeteX Unit DDC Controls
- 304 SS CW coil casing with a phenolic protective coating
Components
A. 2” MERV 8 pre-filter
B. 4” MERV 14 final filter
C. Enthalpy Flat Plate Heat Exchanger
D. Hot water coil with glycol E-Fin
E. Chilled water coil with glycol in E-Fin
F. ECM SA blower
G. 2” MERV 8 pre filter
H. ECM EA blower
If you are looking for a custom air handling solution that prioritizes energy efficiency and performance, contact XeteX for your next project.